3051
Newfangled Mill Wizard / Re: Whoops: Parameters not working
« on: March 04, 2013, 10:13:34 PM »
Ron a Drill cycle can have Ztop anywhere +/- it does not have to start at Z0 The ztop is defined before the Cycle call and retracts back to where ever you want with the R value.
The G98/99 also control the R values so you can have Ztop defined at teh start AND the G98 will retract back to that point in lue of the R value.
NOW IF you do not define the Rvalue then Ztop will be Z0 and the retract will be Z0 which is NOT always correctly applied as to G98/99 mode
Just a thought, (;-) TP
The G98/99 also control the R values so you can have Ztop defined at teh start AND the G98 will retract back to that point in lue of the R value.
NOW IF you do not define the Rvalue then Ztop will be Z0 and the retract will be Z0 which is NOT always correctly applied as to G98/99 mode
Just a thought, (;-) TP