5431
General Mach Discussion / Re: G31 Probe problem
« on: August 05, 2011, 11:18:31 AM »
I am not sure I know of any config setting that would effect it that way. I do not have a machine setup here at the house to test probing with Mach3 and Vista64 do not get along (;-) and will not simulate correctly. SO I cannot say one way or the other. BUT looking at the test vid would indicate there IS a problem. You can see and hear the difference. I used a sound analyser to see the ramp and decay of the sound the motors made.
Many years of loud noise leaves you half deaf in many freq ranges so I have to SEE the sound sometimes.
(;-)TP
Many years of loud noise leaves you half deaf in many freq ranges so I have to SEE the sound sometimes.
(;-)TP