1371
General Mach Discussion / Re: Yet Another Z-Axis question (Safe-Z)
« on: March 12, 2015, 12:03:45 AM »
K so you really did not setup SafeZ in mach3.
Ok from the main page go to the top menu bar select Config. From there go down to SafeZ setup. A window will pop up and from THERE you set up the safeZ function.
Select the option that suits your application best.
Now to your BINGO above you were setting the Retract level of the Canned cycle G81 R0.10 To R0.11. THAT level will also CHANGE according to the G98/G99 mode that is set for the canned cycle. (;-)
(;-) TP
Ok from the main page go to the top menu bar select Config. From there go down to SafeZ setup. A window will pop up and from THERE you set up the safeZ function.
Select the option that suits your application best.
Now to your BINGO above you were setting the Retract level of the Canned cycle G81 R0.10 To R0.11. THAT level will also CHANGE according to the G98/G99 mode that is set for the canned cycle. (;-)
(;-) TP