2634
« on: August 14, 2013, 11:20:50 AM »
HIYA SCott, It does not work here. I installed the plugin and then reloaded mach3 then set the userLED.
When I invoke a G31 it does NOT lite up the led. I tested the Userled with CB code and it works fine I can turn it on and off.
Sense you are doing the Plugin, the Function I was after was IF the Probed trips AND a G31 was NOT called then it issues a FULL STOP to mach3. It is called "protected mode" . It is to protect the probe when you are moving around getting into a position to probe. It does need to be able to be turned on and off when needed. It could be done via macro M*********x.
Thanks (;-) TP