5548
« on: July 17, 2011, 10:36:13 AM »
Toms CCC stock Plugins run fine here without error and I tend to stretch testing to a fault.
The dweel can be set several ways . the normal way is throught your CAM package. You set the amount you need to do a clean pierce BUT not any longer as IF you dwell too long the hole gets large and the plasma will loose the arc and the CCC functions will shut off the arc.
Another dwell that shows up from time to time is the M3 dwell in M3ch itself It is located in the Config/portspins/spindle section all dwells here should be OFF.
Tha issue is the only one that I know of that will shut off the Gcode program but NOT Estop the machine.
Just a thought, (;-) TP