1481
General Mach Discussion / Re: Maximum processing speed?
« on: February 13, 2015, 01:15:26 AM »
Looking at your Gcode it is saturated with micro XYZ moves in the range of .0001". I don't think you willl EVER get that to run efficently. Mach3 or any other controller will never be able to get up to speed.
You would do well to repost the Part with a reasonable Move resolution.
Also use mach3 runtime estimate as a reasonable RUNTIME. Basing a runtime on Distance x feedrate will not be a realistic value by a long shot.
Just a thought, (;-) TP
You would do well to repost the Part with a reasonable Move resolution.
Also use mach3 runtime estimate as a reasonable RUNTIME. Basing a runtime on Distance x feedrate will not be a realistic value by a long shot.
Just a thought, (;-) TP