Messages

5271

General Mach Discussion / Re: Kernel speed set to high on z axis and will not save calibration.

« on: September 01, 2011, 11:48:14 AM »

You will find that some entries are with an enter press and some are without an enter press SO yes it was an appropriate question to ask.  You have no idea how many times that was the problem.

(;-) TP

5272

General Mach Discussion / Re: version 3.043.022, skiping G 53 command's

« on: August 31, 2011, 08:55:32 PM »

The ; is a startpoint for a comment on a gcode line any thing to the right of it is sent to the message bar.

Old school, (;-) TP

5273

General Mach Discussion / Re: version 3.043.022, skiping G 53 command's

« on: August 31, 2011, 08:30:22 PM »

Remove the ";".

(;-) TP

5274

Mach3 under Vista / Re: Unable to use SCREEN4 Under Windows7 31 bit

« on: August 31, 2011, 03:46:13 PM »

(;-) Art resended his statement Seems someone got it working over at Yahoo site.

(;-) TP

5275

Mach3 under Vista / Re: Unable to use SCREEN4 Under Windows7 31 bit

« on: August 31, 2011, 02:18:11 PM »

Art said he did not think it would run under win7.

Sorry, (;-) TP

5276

General Mach Discussion / Barcode Plugin *** Andrew question

« on: August 31, 2011, 01:19:32 AM »

Andrew I am working with the Barcode Plugin. Is there a NotifyPlugins() call to activate the load Barcode button??

I am working on a system that does NOT have a mouse and I need to create a Button that I can assign a hotkey to to active the barcode function. As it is I have to go to the top menu and select the Plugin control then selct the load barcode selection. Without a mouse that is TOUGH to do .

Thanks (;-) TP

5277

General Mach Discussion / SheetCam and MACH3 and Barcodes

« on: August 30, 2011, 09:22:50 PM »

For the ones using Scam with Mach3 it is now possible for Scam to generate Barcodes from the report generator. This is really handy for those that use a Barcode scanner to load Gcode Programs into Mach3.

I use it to generate a JOB report from Scam to go in the Job package. Then at CUT time the Guys can pull the report out and scan in the correct Gcode Program into MACH3 . Just makes it a little easier and lessens the chance of error as some cuts look a LOT alike.

Just a thought, (;-)TP

5278

General Mach Discussion / Re: Match 3 Information

« on: August 30, 2011, 04:51:56 PM »

If you like to READ I would suggest this book for beginners.

http://www.cncintro.com/cnctoc.html

5279

General Mach Discussion / Re: Input pin and Zero Plate

« on: August 29, 2011, 07:46:40 PM »

Good Job Guys, (;-) TP

5280

General Mach Discussion / Re: MACH3 Manuals and Docs

« on: August 29, 2011, 02:12:10 PM »

Dave if you did a screenset for the dark side you could retire early(;-)

(;-) TP