5913
« on: May 02, 2011, 10:25:09 AM »
That should have read First in Last out for functions.
I tested here and all is well IF you cancell out the G83 AND G16 after you stop. Issue a G80 G15
I stopped inside the drill cycle FH/stop then applied G80 G15 and all was well.
I restarted with RFH and all was well it restarted perfectly.
I Estopped and then cancelled out and all was well. Restarted with RFH ok.
NOW IF you do not cancell out both ,the active MODE will still be in effect. If you just cancell out the G16 then the G83 is still active AND will move to the next position commanded and START the drill cycle.
RFH gives you a way to restart in the proper mode to continue.
NOTE just make SURE the Z is UP to a clear Z position before you restart with a RFH or SNAP goes the bit. Mach gives you a screen to make sure the clear move is correct.
(;-) TP