1231
General Mach Discussion / Re: Strange, Help, Motor ATuning alters after G-Code loaded, Restart M3, it's fine!
« on: April 27, 2015, 08:28:25 PM »
Sorry but I have no idea what you are trying to do or say.
" G90 G94 G91.1 G40 G49 G17" You need to put the G90 and G91.1 on seperate lines
G28 G91 Z0. send the z to the Zhome position(whwere ever that is on your system) via Z0
DO you have the tool length offsets set in the tool table for tool 1 ?
You never go negative in Z so you are not cutting anything.
Can you explain again what it is you need to know ?
(;-) TP
" G90 G94 G91.1 G40 G49 G17" You need to put the G90 and G91.1 on seperate lines
G28 G91 Z0. send the z to the Zhome position(whwere ever that is on your system) via Z0
DO you have the tool length offsets set in the tool table for tool 1 ?
You never go negative in Z so you are not cutting anything.
Can you explain again what it is you need to know ?
(;-) TP