4801
General Mach Discussion / Re: PoppaBear needs some help please!!!
« on: November 27, 2011, 11:40:12 AM »
HIYA SCOtt, What ratio are you tryin to acheive. What you are asking is BIG project for a newbie wanting to do an extreme accurate gear without a gear hobber or gear grinder. Can be done BUT(;-) I would not do it on a custom device for a customer as a first project.
Look over at Surplus Center at their selection of worm gear reduction drives I see a couple of through hole 20:1 wormdrives for $89 AND they are rated for about 2hp .
(;-) TP
Look over at Surplus Center at their selection of worm gear reduction drives I see a couple of through hole 20:1 wormdrives for $89 AND they are rated for about 2hp .
(;-) TP