5801
General Mach Discussion / Re: Mach3, Probe, and Digitize Wizard Issue
« on: June 01, 2011, 07:08:44 PM »
Does the rest of you machine work?
Are you sure that you have the probe checked for ON in config/ports and pins AND it is set for port1 pin10 ?? sure you do not have duplicate pin settings??
Next test would be to unplug the cable going from the PC TO the G540 and short pins 10 and 20 momentarily and ckeck the LED again it should change state.
(;-) TP
Are you sure that you have the probe checked for ON in config/ports and pins AND it is set for port1 pin10 ?? sure you do not have duplicate pin settings??
Next test would be to unplug the cable going from the PC TO the G540 and short pins 10 and 20 momentarily and ckeck the LED again it should change state.
(;-) TP