4190
« on: June 25, 2012, 09:02:15 PM »
What I meant by the R&P was a FULL length R&P the maximum length of the Material stock Most stock comes in 20-24' lengths. You will use the full stroke of the R&P each load. With R&P you have an end clamp to grab the material. Then it is a continuous PUSH until you run OUT of stock.
I have a running screenset now AND I have cut you over 962 pieces 2" long(;-)
It has MORE features such as a material table to select Material From(tool table) That YOU can edit on the fly if needed. When you select the Number it presets the CUT parameters such as Materail Desc /type , Width of stock, Cut Feedrate, ETC. Then creates a custom CUTFILE just for that application and loads the system ready to cut.
You can FRO the CUT Feedrate OR the BarFeed Feddrate ON THE FLY.
It has a Parts counter both Num of parts, Num of CUT parts and Num of Parts to go.
It also has a Stop "Reload Stock" Flashy LED that you cannot ignore, it is a FULL page large and VERY blinky. (;-)
Make have to build a new saw now(;-)
(;-) TP