8951
G-Code, CAD, and CAM discussions / Re: This program will not run on Mach3
« on: February 28, 2009, 02:47:01 AM »
You have not succeeded in attaching the code Brian.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
It's completely unnecessary to move the table manually - Move the part to its new position, jog the table to where it needs to be, and re-set the DRO. This is the more conventional way of handling your problem.
Regards,
Ray L.