Messages

911

Third party software and hardware support forums. / Re: Z-Axis not responding / moving - Help debugging

« on: February 20, 2018, 07:22:30 AM »

Hi John,

If you could attach your .xml file then we may be able to spot the problem.
This file is in your Mach3 folder and it is called <your profile>.xml (typically Mach3Mill.xml)

Tweakie.

912

General Mach Discussion / Re: Mach3 motor outputs issue

« on: February 20, 2018, 06:19:01 AM »

I am pleased you have it sorted. 
I was just concerned that you had posted a question 2 weeks ago and it had not received a reply.

Tweakie.

913

General Mach Discussion / Re: Mach3 motor outputs issue

« on: February 20, 2018, 05:29:49 AM »

Hi AndreiD,

Could you please attach your .xml file.
This file is in your Mach3 folder and it is called <your profile>.xml (typically Mach3Mill.xml)

Tweakie.

914

Post Processors / Vectric post processor for Auggie laser operation.

« on: February 19, 2018, 06:43:30 AM »

This is my Vectric post processor for Auggie laser operation.

Tweakie.

915

Post Processors / Vectric post processor for Mach 4 laser operation.

« on: February 19, 2018, 06:41:18 AM »

This is my Vectric post processor for Mach 4 laser operation.

Tweakie.

916

Post Processors / Vectric post processor for Mach3 laser operation.

« on: February 19, 2018, 06:39:58 AM »

This is my Vectric post processor for Mach 3 laser operation.

Tweakie.

917

Post Processors / LazyCam post processor for Mach3 laser operation.

« on: February 19, 2018, 05:55:53 AM »

This is my LazyCam post processor (incorporating the M11/M10 commands) for Mach3 laser operation.

(Please note that Mach3 version .057 or later is required for correct operation of the M11/M10 commands).

Tweakie.

918

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: February 19, 2018, 04:55:23 AM »

Judging by the photos that you posted, you never did quite get to the same level of fine detail in terms of cutting out the bicycle as the pros? How fine can your setup get do you think?

Strange comment to make. Perhaps you need to read a few more of the posts.    http://www.machsupport.com/forum/index.php/topic,12444.msg102590.html#msg102590

Tweakie.

919

Post Processors / DotG post processor for Mach3 Laser operation.

« on: February 19, 2018, 04:36:55 AM »

This is my DotG post processor for Mach3 laser operation.

Because the M11/M10 commands only operate upon axis movement and because DotG only produces it’s 'dot' output when the X and Y axis are stationary an imaginary B axis has been used to enable correct operation.
Within Mach3 the B axis is enabled and set-up with low step value - the Velocity / Acceleration can then be set to determine the ‘dot’ burn time.

Tweakie.

920

General Mach Discussion / Re: LOST BUT NOT BEATEN

« on: February 19, 2018, 01:39:15 AM »

Hi Forbri40,

I have sent you a PM.

Tweakie.