1281
General Mach Discussion / Re: Setting up Longs Motor breakout board
« on: October 17, 2019, 02:22:45 AM »
In your attached .xml you have a conflict of pins where pins 6 and 9 are both defined twice so that is unlikely to work.
You perhaps need to set-up all your Ports and Pins as shown in the Longs Motor .pdf you have linked then attach your .xml (it needs to have a unique name to attach)
You perhaps need to set-up all your Ports and Pins as shown in the Longs Motor .pdf you have linked then attach your .xml (it needs to have a unique name to attach)