5091
General Mach Discussion / Re: Jerky Motion 5 Axis Mill........(sound familiar?)
« on: September 01, 2013, 04:53:25 AM »
Hi Matt,
It could well be your BobCad generated GCode which is creating the jerky motion (perhaps if you zip and attach your GCode file others could test it and confirm one way or the other ?). Perhaps also attach your current profile .xml file then it can be established if you have any Mach3 setup issues.
Tweakie.
It could well be your BobCad generated GCode which is creating the jerky motion (perhaps if you zip and attach your GCode file others could test it and confirm one way or the other ?). Perhaps also attach your current profile .xml file then it can be established if you have any Mach3 setup issues.
Tweakie.