4531
Third party software and hardware support forums. / Re: ST-V2 5 axis breakout board
« on: November 11, 2014, 04:51:43 AM »
From just a quick look at the installation instructions E-Stop is configured as Active Low.
To follow their wiring instructions your E-Stop switch should be 'normally open' contacts and only closing the contacts when E-Stop is pressed. Is this the way you have it wired ??
Tweakie.
To follow their wiring instructions your E-Stop switch should be 'normally open' contacts and only closing the contacts when E-Stop is pressed. Is this the way you have it wired ??
Tweakie.