7931
General Mach Discussion / Re: Milling marks????????
« on: September 03, 2010, 05:34:59 AM »
Just a thought, well a wild guess really, I had a problem which looked similar to this which was caused by tiny particles welding to the cutter tip and making unwanted gouge marks. This was with polycarbonate - the same problem did not occur with Plexiglass / acrylic.
Could you perhaps try a different material, with a higher melting point, and then see if the same problem occurs.
Tweakie.
Could you perhaps try a different material, with a higher melting point, and then see if the same problem occurs.
Tweakie.