7271
General Mach Discussion / Re: Ordered 3 Dugong drives for my Hurco
« on: March 25, 2011, 10:14:26 AM »
Looking forward to following the thread and seeing the pictures.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I did place another VFD I had on hand on the back of the Z axis rather than in the control panel
Now they're no more interference to the computer.
think there must still be a gremlin somewhere as I can highlight and zero an individual axis ok using the keyboard but when I use the onscreen button to zero that axis it does not zero but runs away until stopped by the limit switch??