4251
FAQs / Re: Mach 3 only loads half of the gcode
« on: August 23, 2015, 07:20:15 AM »i am having the same issues only a portion of the gcode loads up when I load it but that's when the parallel drivers are installed when i uninstall mach3 and install it again without the parallel driver then the entire gcode loads. Any help would be appreciated.
Without the licence file installed Mach3 operates in Demo mode. It will only run the first 500 lines of Gcode with the parallel port drivers installed - purchasing and installing the Mach3 license file removes this restriction.
Tweakie.