6611
Mach SDK plugin questions and answers. / Re: Impact engraving plugin
« on: August 10, 2011, 08:40:31 AM »
Se vuoi farlo ti troverà il modo.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I found, that if I put it into the same power outlet as the controller, the steppers gets a lot more noisy.The same applies to Ground loops which is why GND connections are only made at one end of shielded cables.
Tweakie, Thanks for the information. I'm ordering Gearotic Motion right now. I guess that should solve my remaining misunderstanding about this project plus allow me to do a whole lot more later.
Thanks,
Jim Gray