8111
General Mach Discussion / Re: Is anyone else using E1P1 / E1P0 to switch output #1 ?
« on: July 05, 2010, 05:50:47 AM »
Thanks Ian,
Due to location of my equipment I am unable to measure the pulse timing at present but I would be most interested to know what it is.
M10 and Z control files attached.
(I am changing the Z dir pin, in ports and pins/motor outputs, to my laser trigger pin16).
Tweakie.
Due to location of my equipment I am unable to measure the pulse timing at present but I would be most interested to know what it is.
M10 and Z control files attached.
(I am changing the Z dir pin, in ports and pins/motor outputs, to my laser trigger pin16).
Tweakie.