4061
General Mach Discussion / Re: Carving in reverse
« on: December 04, 2015, 01:27:22 AM »
I am pleased you have it working.
The Velocity and Acceleration figures are arrived at by 'trial & error'.
Just one axis at a time, increase Velocity until the axis starts to stall (shift + arrow key - fast jogging) then reduce the figure by 30%. Repeat for each axis and do a similar thing with Acceleration.
Tweakie.
The Velocity and Acceleration figures are arrived at by 'trial & error'.
Just one axis at a time, increase Velocity until the axis starts to stall (shift + arrow key - fast jogging) then reduce the figure by 30%. Repeat for each axis and do a similar thing with Acceleration.
Tweakie.