1441
Mach4 General Discussion / Re: NOOB Alert (MACH4 & 57CNC Issues)
« on: June 10, 2019, 02:37:42 AM »
Just an observation from your video...
You are using USB connection between your PC and the 57CNC and you also appear to have a couple of USB memory sticks connected to the PC.
It depends on exactly how the PC polls it's USB hub or hubs but leaving memory sticks in the PC when running Mach3 and using a USB connection to the motion controller can be very bad news indeed - I have not tried it but maybe Mach4 is similar ?
I think you should remove the memory sticks and change your PC to 57CNC connection to Ethernet (which is far superior to rejection of electrical noise issues etc.) and see if this resolves the problems.
Tweakie.
You are using USB connection between your PC and the 57CNC and you also appear to have a couple of USB memory sticks connected to the PC.
It depends on exactly how the PC polls it's USB hub or hubs but leaving memory sticks in the PC when running Mach3 and using a USB connection to the motion controller can be very bad news indeed - I have not tried it but maybe Mach4 is similar ?
I think you should remove the memory sticks and change your PC to 57CNC connection to Ethernet (which is far superior to rejection of electrical noise issues etc.) and see if this resolves the problems.
Tweakie.