1821
General Mach Discussion / Re: Can't send email to tech support
« on: September 28, 2018, 04:25:22 AM »
Probably the best way forward would be to submit a ticket from the Help Desk http://support.machsupport.com/
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi Tweakie,
I now have my laser “cutting” very welll. I was not aware that Mach3 Could be used for engraving. So I am very interested in your comment, “ I should perhaps mention that engraved items, such as this tree image (330mm x 280mm) can easily be laser reproduced by either Mach3 or Mach4 without generating (or using) any Gcode at all”.
Could you point me to where I can learn more about this process ?
Thank you,
Chuck
Try doing one on granite 300 mm square.