Messages

8831

General Mach Discussion / Re: Software to convert Dxf to Gcode, aka CAM. Recommendations wanted

« on: January 09, 2009, 09:24:23 AM »

I use CamBam for dxf to GCode - it's also extremely good at creating the tool radius offset paths. Easy to use and fully supported by active forum and it's Free.

Tweakie.

8832

Show"N"Tell ( What you have made with your CNC machine.) / Re: Routing Wood

« on: January 07, 2009, 05:43:13 AM »

Teak, being a particularly oily wood, does not take too kindly to double sided sticky tape - so I thought that the vac table would hold it better. Unfortunately the teak blank was not flat enough and moved during the first (particularly savage) cut. Luckily the through hole (just below the letter E) can be easily filled and the job was completed on the reverse side using double sided sticky tape after all. Let this be a lesson to me.

This is nothing special but I thought you guys may like to see the photo's.

Tweakie.

8833

Show"N"Tell ( What you have made with your CNC machine.) / Re: terrain

« on: January 07, 2009, 05:31:03 AM »

That is just brilliant - what more could I say.

Tweakie.

8834

Tangent Corner / Re: Careful where you put your tattoo's!!!

« on: December 30, 2008, 04:04:00 AM »

Nice one Ed.

8835

Tangent Corner / Re: What the.........?

« on: December 24, 2008, 06:10:53 AM »

Bump.

I just knew that somebody would make one.

If you haven't already visited there are lots of ideas and info on this site.

http://webferret.search.com/click?wf6,vcarve,13,www.cnc-plasmaschneidanlage.com%2Fhtml%2Fphotovcarve_cnc_fotos_frasen_b.html,,entireweb,1

Regards, Tweakie.

8836

Show"N"Tell ( What you have made with your CNC machine.) / Re: Skeleton Clock

« on: December 24, 2008, 02:31:33 AM »

Excellent job David. Roger will be proud of this one.

Thanks for posting, it's things like this that give us all inspiration.

Regards, Tweakie.

8837

Show"N"Tell ( What you have made with your CNC machine.) / Re: Last minute Gift ;o)

« on: December 22, 2008, 02:56:18 AM »

Wonderful job Dave.

With work like that you don't need a wood router just a bigger mill (for larger signs).

Regards, Tweakie.

8838

Show"N"Tell ( What you have made with your CNC machine.) / Re: Another TCL Video

« on: December 20, 2008, 02:50:06 AM »

Very impressive.

Regards, Tweakie.

8839

G-Code, CAD, and CAM discussions / Re: G-Code scaling program, mm to Inches and back

« on: December 19, 2008, 09:15:36 AM »

Thanks Graham, nifty little program. I have used it a couple of times now and it was brilliant.

Regards, Tweakie.

8840

Share Your GCode / Re: CNC robot arm project

« on: December 19, 2008, 03:08:57 AM »

Hi all,

I think it's brilliant.
If nobody else likes it, then it's all my fault.

Regards, Tweakie.