421
General Mach Discussion / Re: How to properly pause and resume?
« on: September 03, 2021, 11:30:46 PM »
It's a long while since I have needed to do this so I may have missed something but I think this is the way...
To pause, press Feed Hold and then when motion ends press Stop.
Note the line number.
To resume, check line number is correct - restart spindle, coolant, etc. then press Start.
Tweakie.
To pause, press Feed Hold and then when motion ends press Stop.
Note the line number.
To resume, check line number is correct - restart spindle, coolant, etc. then press Start.
Tweakie.