Messages

211

Tangent Corner / The Birds rule.

« on: May 12, 2019, 08:33:04 AM »

...and you thought you lived in a rough neighbourhood ?

212

General Mach Discussion / Re: HELP g-code command lines and coordinates not synchronized

« on: May 12, 2019, 07:52:00 AM »

Could be, but the Gcode itself is only 10 lines long.

Tweakie.

213

General Mach Discussion / Re: HELP g-code command lines and coordinates not synchronized

« on: May 12, 2019, 06:51:32 AM »

Here the next command line is not executed until the axis movement from the previous command line is complete.

Tweakie.

214

General Mach Discussion / Re: HELP g-code command lines and coordinates not synchronized

« on: May 12, 2019, 06:11:45 AM »

Absolutely nothing wrong with your Gcode.
Here, the m113 executes before the X axis starts to move and the m115 executes after the Y axis has returned to zero.

Could be that the problem lies within your NVUM controller software plugin but I have no way of testing or confirming this.

Tweakie.

215

General Mach Discussion / Re: HELP g-code command lines and coordinates not synchronized

« on: May 12, 2019, 05:09:23 AM »

Could you perhaps .zip and attach your Gcode file ?

Tweakie.

216

General Mach Discussion / Re: HELP g-code command lines and coordinates not synchronized

« on: May 12, 2019, 02:49:08 AM »

Hi Axia,

I have just noticed that your NVUM controller does not support the M11 / M10 command set so please disregard my earlier post.

Tweakie.

217

General Mach Discussion / Re: HELP g-code command lines and coordinates not synchronized

« on: May 12, 2019, 01:19:00 AM »

Hi Axia,

For laser use the M3 / M5 commands are not really suitable because of their inherent delay. To resolve this issue the commands M11Px / M10Px (for Mach3) and M62Px / M63Px (for Mach4) were created to synchronize the Output# switching ON / OFF in time with the commencement of axis movement.

There is a little more explanation here; http://hobbycncart.com/publ/cikkek/mach3_temaju_cikkek/switching_a_laser_under_mach_control/8-1-0-29

Tweakie.

218

General Mach Discussion / Re: Parallel port issue

« on: May 10, 2019, 06:17:29 AM »

Reuelt has made a good point - you need to enable the Charge Pump (Config / Ports & Pins / Outputs) if you have your G540 Charge Pump turned on.

Tweakie.

219

General Mach Discussion / Re: Parallel port issue

« on: May 10, 2019, 05:19:34 AM »

I have no idea. But it is fairy new.  How can I tell?

This may help you decide;

https://www.machsupport.com/forum/index.php?topic=34848.0

Tweakie.

220

Spanish / Re: mach3 +nema23+tbb6600

« on: May 10, 2019, 04:36:03 AM »

Excellent