3861
General Mach Discussion / Re: axis stall
« on: January 28, 2016, 03:41:47 AM »
This does indeed sound a bit weird.
Which version of Mach3 are you using ??
If you attach your .xml file (the one from your Mach3 folder named <your profile>.xml [typically Mach3Mill.xml]) copy and rename it to paragon.xml then use the 'Reply' tab and Additional Options to post it - I will see if I can spot any problems in your set-up that may be causing the issue.
Tweakie.
Which version of Mach3 are you using ??
If you attach your .xml file (the one from your Mach3 folder named <your profile>.xml [typically Mach3Mill.xml]) copy and rename it to paragon.xml then use the 'Reply' tab and Additional Options to post it - I will see if I can spot any problems in your set-up that may be causing the issue.
Tweakie.