4421
Show"N"Tell ( What you have made with your CNC machine.) / Re: Night Lite
« on: February 22, 2015, 11:17:26 AM »
Very nice work madeintheshed.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
- Is it possible to hard wire the Slave Axis (A) with X? This could free up a stepper port on the Gecko G540?
Hey guy's I have a PCI LPT card problem of my own to.
Somehow two inputs 11 and 13 stopped working on my MACH 3 machine. So I thought I would insert a PCI LPT card in to the computer and change the configuration of the Port in Mach3 and that it would solve my problem. Well partly it did all my inputs are now working, but unfortunatley the outputs that drive the motors don't work. When I try to move the an axis nothing happens. The DRO number increse and decreas.
This is the LPT confugiraton of the new LPT card.
I/O range BC00-BC07
I/O range B880-B887
Mem range: FEAFF000 - FEAFFFFFF
Any ideas? Not the correct driver for the PCI card perhaps?
Best regards
Aleix