3001
General Mach Discussion / Re: can a Mach3 macro toggle an output pin?
« on: February 16, 2017, 03:29:44 AM »
It is happening but it is far too quick for anything to take effect.
To slow it down try adding :
While IsMoving ()
Wend
In between each line.
If that does not produce enough delay then also add a pause in between each line :
Code "G4 P#"
Where # is the amount of the delay you need.
Tweakie.
To slow it down try adding :
While IsMoving ()
Wend
In between each line.
If that does not produce enough delay then also add a pause in between each line :
Code "G4 P#"
Where # is the amount of the delay you need.
Tweakie.