781
General Mach Discussion / Re: Pins and Ports for Fireball V90
« on: September 14, 2020, 01:43:47 AM »
Does your machine have LPT Parallel Port or Ethernet ?
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I’m a newbie to anything Cnc. I just won a chinacnczone 6090 machine at a local auction. It came with a pc thats rubbing mach 3. Along with cnc usb controller software. I do not have a clue what I’m doing. Where do I begin.
tried to post, said it was spam. Everything I wrote is gone. Nice...
I have set up as you suggested and I only run the Z10 Z0 code 20 times without moving the block as my problem is consistently creeping up. By using a feeler gauge the result had about 0.05 error so average out it had about 0.0025mm error each time it run.
with the same setup, Z5 Z10 Z0 code made almost no error as I do not have a feeler gauge small enough to fit the gap if there is any.