31
General Mach Discussion / Re: Odd Jogging Behaviour
« on: January 17, 2024, 09:46:50 AM »
Hi Bruce from NZ,
Perhaps not what you want to hear but it is the best advice you could be given…
Junk the Bitsensor board, save yourself a lot of time and hassle, and buy a USA or EU manufactured motion controller which has a greater degree of support. That way you will be able to build a reliable machine capable of producing quality work.
Plasma cutters have a particular set of requirements (such as pierce delay, torch height control, etc., etc.) and these are just not fully supported by the Bitsensor.
Tweakie.
Perhaps not what you want to hear but it is the best advice you could be given…
Junk the Bitsensor board, save yourself a lot of time and hassle, and buy a USA or EU manufactured motion controller which has a greater degree of support. That way you will be able to build a reliable machine capable of producing quality work.
Plasma cutters have a particular set of requirements (such as pierce delay, torch height control, etc., etc.) and these are just not fully supported by the Bitsensor.
Tweakie.