2181
General Mach Discussion / Re: Spindle control from Mach3
« on: February 25, 2018, 04:17:11 AM »
The available documentation on the HX-WS400 is almost non-existent but it does appear to accept a 5Volt PWM for speed control. My best suggestion is that you set-up Mach3 to output a PWM on an output pin then try connecting this to your controller.
You may find this thread and the associated links of interest. http://www.machsupport.com/forum/index.php/topic,27447.0.html
Tweakie.
You may find this thread and the associated links of interest. http://www.machsupport.com/forum/index.php/topic,27447.0.html
Tweakie.