7431
General Mach Discussion / Re: Mill or Router - which is best for this application?
« on: February 28, 2011, 10:33:41 AM »
Hi Jen,
The Epilog sounds like a good choice.
Just one point to keep in mind is that organics such as shell, bone, leather etc really stink when you attack them with a laser. I am not sure about the composite 'ablam' because I have never tried it but depending on your location (if you have neighbours) you may need a HEPA filter attached to your air extraction system. They are not that expensive but still a bit of extra cost to factor into the equation.
Tweakie.
The Epilog sounds like a good choice.
Just one point to keep in mind is that organics such as shell, bone, leather etc really stink when you attack them with a laser. I am not sure about the composite 'ablam' because I have never tried it but depending on your location (if you have neighbours) you may need a HEPA filter attached to your air extraction system. They are not that expensive but still a bit of extra cost to factor into the equation.
Tweakie.