1371
Show"N"Tell ( Your Machines) / Re: Cnc Id od and thread grinder
« on: August 01, 2019, 10:29:38 AM »
Looking good (either way up )
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
While you are on with mach4 not installing
If you have win 10 N the last two dev releases industrial or hobby will fail with missing mfplat.dll after contact with James it’s a windoze problem . You will need to dl and install the media feature pack from MS it seems that newfangled have put in place the ability to have a vidieo window
1 question I am planning on using a stepper for the spindle ( Low rpm) and a y axis for the thread grinding. Is there a way to config mach that way. 1 time keep turning 2nd move proportionally to the z axis. ( the 2nd I can do with gcode easy enough).
Ah, bummer. Do you just have two different profiles setup then?