1901
German / Re: Hilfe bei der Laser Einrichtung
« on: August 11, 2018, 05:44:55 AM »
Hi Matt,
The problem with the M3/M5 commands is that they are slow to operate and unwanted laser burn is often produced.
The command M11P1 will turn On Output #1 and the command M10P1 will turn Off Output#1 so this Output# has to be set to the Port & Pin number used to turn your laser On/Off. These commands are much faster and have been incorporated within Mach3 especially for laser use.
For the M11P#/M10P# commands to work correctly you also need to be using Mach3 version .056 or later.
Tweakie.
The problem with the M3/M5 commands is that they are slow to operate and unwanted laser burn is often produced.
The command M11P1 will turn On Output #1 and the command M10P1 will turn Off Output#1 so this Output# has to be set to the Port & Pin number used to turn your laser On/Off. These commands are much faster and have been incorporated within Mach3 especially for laser use.
For the M11P#/M10P# commands to work correctly you also need to be using Mach3 version .056 or later.
Tweakie.