2711
General Mach Discussion / Re: Setting up Mach3 using USB
« on: June 01, 2017, 01:28:40 AM »
Which USB Control Card are you using ?
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
the only diode I have is a 1N4007N, is is ok?
Do While Getvar(3) < 360.000 * Getvar(8)
I do not have any melinex but I do have some copper shim stock and a mill. Can I make a US version with those you think?