1771
General Mach Discussion / Re: invisible gremlins
« on: October 27, 2018, 04:32:04 AM »
Assuming I have the correct .xml...
As ZASto has said your accelerations are too high.
I think you need to make many changes to your setup but just make one at a time, saving the change, restarting Mach then checking the result.
I suggest...
1) Set your X an Y axis Velocity to 2000 and Acceleration to 200.
2) Z acceleration to 90
You have a conflict of Pins where you have Enable1 set as Port 1 Pin 14 and also X Axis Direction Pin as Port 1 Pin 14 - this needs correcting.
You have M3 set for Output#6 which is not enabled or set to any Port or Pin.
There are many other things that need attention but just try those to start with.
As ZASto has said your accelerations are too high.
I think you need to make many changes to your setup but just make one at a time, saving the change, restarting Mach then checking the result.
I suggest...
1) Set your X an Y axis Velocity to 2000 and Acceleration to 200.
2) Z acceleration to 90
You have a conflict of Pins where you have Enable1 set as Port 1 Pin 14 and also X Axis Direction Pin as Port 1 Pin 14 - this needs correcting.
You have M3 set for Output#6 which is not enabled or set to any Port or Pin.
There are many other things that need attention but just try those to start with.