2491
General Mach Discussion / Re: Connection of Mach3 to TB6600 Drivers
« on: September 25, 2017, 01:33:43 AM »
It’s all looking good John
(As you progress I think you will find that there is too much flex in the unsupported rails – at some later date, changing to the fully supported type will make a considerable difference in performance).
Tweakie.
(As you progress I think you will find that there is too much flex in the unsupported rails – at some later date, changing to the fully supported type will make a considerable difference in performance).
Tweakie.