4081
LazyCam (Beta) / Re: Circle gcode only an arc
« on: August 12, 2011, 05:36:40 PM »
Looks like you have a demo of Mach3, which limits you to 50 lines of code from LazyCAM.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
my original drivers were causing grief with motors stalling at full speed
.........and I have connected the insides together with a shaft, the idea behind that is that if one starts to labour a bit the other one will help keep it running, kinda like hooking up two locomotives in tandem. Maybe a bit of overkill, but it works.
You're an early riser Gerry.
For the life of me I can't find the 3.42.040 version to download!
I'm also getting this when doing an m6:
tool change z position error!!!!!!
Tool change z position
can NOT be above z=0
system going in to E-stop
(ok)
any thoughts?