1681
General Mach Discussion / Re: new guy
« on: October 15, 2015, 01:43:32 PM »
There are videos on Machsupport.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Acceleration could be an issue, so when changing direction, the motors could miss steps... so I tried feedrate 200 instead of 2000
I hear you saying backlash!! But wait! looks like too much for backlash.
With the bit back at x-0, y=0, I change the bit manually - and then Set the z height of the bit - using the slipping a sheet of paper under the bit end method ...
I then click ref all home to zero the new z value