5801
General Mach Discussion / Re: Noob with SLOOOWW 3D Carving Speeds- HELP!!
« on: November 18, 2008, 05:17:20 PM »
Does the kernel speed limit accel speeds?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Thank you for the replies, I have found MasterCam x2 mr2 sp1 as low as $50 us. It is not a crack etc.
Terry
Question on switches. Does the dro indicate the small movement created when the stepper is powered after being shutoff?
This might sound stupid - but why can't you run both motors from the same driver .........