3081
General Mach Discussion / Re: MAC ANYONE!
« on: September 30, 2013, 11:38:25 PM »
I should have said that although Mach3 will run, it probably won't be able to run a machine??
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
When I get to Internet Protocol TCP/IP I clicked on it and selected properties where I entered the IP address 10.9.9.2 and entered
in subnet mask; 255.255.255.0 the OK. Back to the TCP/IP screen. Not sure if this was correct but I clicked on INSTALL Then I was
asked "Client", "Service", "Protocol". I selected "Protocol" and was then told "unable to find drivers"
Again I'm up against the wall. What do I do?
Jim
The Ethernet cable is connected at the computer and the slow stepper.