5901
General Mach Discussion / Re: New User - Need Post Processor Guidance -
« on: August 21, 2008, 09:42:02 PM »
Nothing to set up. Just pick the appropriate Mach3 post to use, usually the arc ones, metric or inch.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
While I appreciate all the G Code info (It encouraged me to dig in a little deeper), I have been a little confused as to why nobody told me how to do it in Lazycam.
I can see CONFIG - but where the GENERAL CONFiG are?
I have Mach3 ver. 1.84
how do I home x then z ?