1761
General Mach Discussion / Re: Sqauring the Axis
« on: August 31, 2015, 10:03:47 AM »
So you built a table that's 3mm out of square, and you want Mach3 to compensate?
I know I've posted formulas here before in the past, but I'm on very spotty wifi right now and can't search.
You should be aware that there are some instances where the formulas will not work, which will lead to Mach3 trying to "jump" into position, causing stalling or lost steps. I don't recall exactly when this occurs, but it can make formulas unusable in a lot of cases.
I know I've posted formulas here before in the past, but I'm on very spotty wifi right now and can't search.
You should be aware that there are some instances where the formulas will not work, which will lead to Mach3 trying to "jump" into position, causing stalling or lost steps. I don't recall exactly when this occurs, but it can make formulas unusable in a lot of cases.