4211
LazyCam (Beta) / Re: Import DXF
« on: June 08, 2011, 12:26:08 PM »
Save it as a v12 for best results
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Home switches are set to the max positive and 0,0 is at the lower left as it should be
Have just reversed the "X" and "Y" axis as you said but then the axis DRO's are reading + when it should be minus
As for the driver test... I don't quite understand how to ready the result? What's consider good and what's consider bad, what are you suppose to look for in the test?