4031
VB and the development of wizards / Re: DRO color help?
« on: September 23, 2011, 08:48:57 PM »
What's the full path? It should work.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I have tried a 8mm spiral but wasn't impressed as the first cut into each panel would burn edge
You have the velocity set too high for the motors/drives you are running. When the machine makes a diagonal move the actual motor speed has to be a lot higher than the commanded rate to create the commanded feedrate.