101
General Mach Discussion / Re: UC400ETH soft limit problem
« on: April 23, 2019, 08:32:30 AM »This is NOT NECESSARY.
1. If your port 2 of UC400ETH is unconnected you need to pull up or pull down all the input pins (see attached).
It is TTL logic NECESSITY.
If you aren't using the port, then Mach3 does not even look at the pins.
Quote
People on CNCZONE already had false triggering of limit switches with UC400ETH even in 2017. So if CNCDRIVE had fixed the problem, the updated plugin should be already there for automatic update by now in 2019.
This is not a UC400ETH issue, but a breakout board or wiring issue.