3741
General Mach Discussion / Re: Radius compensation within a subroutine
« on: February 27, 2012, 06:47:26 PM »
Comp bugs are not going to get fixed in the current version of Mach3. The new version 4 should work much better.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Thanks, that was indeed the problem. Could you tell me under what circumstances one would use absolute?
Thank you for the reply!
Mach3 Software Requirements seem to indicate that it will work with 64bit OS if you use an external motion controller that is unless I am completely reading it wrong. My question is what does an "external motion controller" do; why do I need one for 64-bit support; and which one should I purchase?